ASI 0196-2-93 Turbo-Pro High-Speed Hand Dryer with HEPA Filter
The ASI 0196-2-93 is a surface-mounted Turbo-Pro automatic hand dryer with a satin stainless steel cover and HEPA filter. The replaceable filter sits in a separate chamber and can be removed without disconnecting the dryer.
Specifications and operation
- Drying: Manufacturer-rated drying time is less than 15 seconds.
- Adjustments: The owner can adjust air speed and warm-air output temperature; heat has an on/off option.
- Dimensions: 8-5/8 in. W x 13-37/64 in. H x 4 in. D.
- Touch-free operation: An IR sensor activates the dryer when hands are placed beneath it. A blue LED in the sensor array guides hand placement, and the dryer shuts off after hands leave the sensing zone.
- Warranty: Five years against defects in materials or workmanship.
Installation
Surface-mount the dryer using the supplied washers and screws or bolts through the back plate into suitable prepared mountings or other hardware appropriate for the wall. Electrical service is supplied and connected by others before the cover is installed. ASI’s adult accessibility installation guidance places the bottom of the sensor lens no higher than 48 in. above finished floor (AFF) with unobstructed reach, or 44 in. AFF when the only access is forward reach over an obstruction with a reach depth greater than 20 in. and less than 25 in. For general utility, ASI gives a sensor-lens height of 44–54 in. AFF; confirm site conditions and applicable requirements.
