ASI 0196-2-00 Turbo-Pro High-Speed Automatic Hand Dryer with HEPA Filter
The white ASI 0196-2-00 is a surface-mounted automatic hand dryer for 220–240 VAC service. Its replaceable HEPA filter is in a separate chamber and can be removed without disconnecting the dryer. An IR sensor activates the dryer when hands enter its sensing zone; the manufacturer specifies a drying time of less than 15 seconds.
Specifications and operation
- Electrical: 220–240 VAC, 50/60 Hz, 4.17 A, 1,250 W.
- Airflow: 32–42 CFM.
- Adjustments: Owner-adjustable air speed and output temperature; heat can be switched off.
- Size: 8-5/8" W x 13-37/64" H x 4" D.
- Shutoff: The dryer shuts off after hands are removed from the sensor zone.
- Warranty: Five years against defects in materials or workmanship.
Mounting and installation
Surface-mount the dryer using the supplied washers and screws or bolts through its back plate. Suitable prepared wall mountings or other hardware for the wall conditions are by others. Electrical service is supplied and connected by others before the cover is installed.
For the manufacturer's adult accessibility guidance, position the bottom of the sensor lens no higher than 48" above finished floor with unobstructed reach, or 44" when the specified forward reach over an obstruction more than 20" and less than 25" deep is the only access. For general utility, the manufacturer recommends a sensor-lens height of 44"–54" AFF. Confirm site conditions and applicable requirements when setting the mounting height.
