ASI 0710 Single Surface-Mounted Toilet Tissue Holder
The ASI 0710 is a single-roll, surface-mounted toilet tissue holder for one standard-core roll up to 5 inches (127 mm) in diameter. Its high-polished chrome-plated steel construction and controlled delivery distinguish it from open-access roll holders.
Capacity and operation
- Holds one standard-core toilet tissue roll up to 5 inches (127 mm) in diameter.
- 18-gauge chrome-plated steel with a high-polish finish.
- Brake springs allow free paper delivery while helping prevent roll over-spin during a fast pull.
- The roll is non-removable until depleted. Its core blocks access to the release catch; remove the core to swing the end support arm away for service-roll replacement.
Mounting and service
For general utility installation, the manufacturer specifies mounting the holder with its center line 32 inches (813 mm) above the finished floor. Secure the back plate through its mounting slots with two #10 self-threading screws (not supplied). The manufacturer’s installation guidance for 2010 ADA Accessibility Standards and 2015 ABA Standards specifies the roll center line 7–9 inches (178–229 mm) in front of the toilet and the roll axis 15–48 inches (381–1219 mm) above the finished floor; this is installation guidance, not a blanket compliance guarantee. Replace the toilet paper on a cycle determined by maintenance needs.
Overall dimensions: 6 inches (152 mm) wide x 2-3/4 inches (70 mm) high.
