ASI 3815-25P Wall-to-Floor Grab Bar with Toilet Tissue Holder
The ASI 3815-25P is a 30" x 33" wall-to-floor grab bar with an integrated toilet tissue holder. It has 1-1/2" O.D., 18-gauge Type 304 stainless steel tubing with the peened (-P) surface. The holder is welded to the bar, and snap-on flange covers conceal the mounting screws.
Configuration details
- 30" x 33" wall-to-floor configuration with toilet tissue holder.
- Concealed mounting flanges are 1/8" thick and 3-1/8" O.D., with two mounting holes and three locking dimples.
- The 22-gauge Type 304 stainless steel covers have a satin finish, measure 3-3/16" in diameter, and snap over the flange dimples to conceal screws.
Installation considerations
Provide suitable anchoring and backing before wall finishing. ASI’s guidance says to use the bar as a template, pre-drill, and fasten each flange with two #10 self-tapping pan-head screws and flat washers (by others), or another fastener system suited to site conditions. The configuration drawing specifies a contractor-provided floor sleeve, 3" long, sized to accept the specified bar O.D. Check floor and wall conditions, fasteners, and required grab-bar placement against the project requirements before installation.
