ASI 0185 Profile Steel Cover Hand Dryer, White
The ASI 0185 is a surface-mounted, touch-free hand dryer with a white porcelain-enamel steel cover and universal 115–240 VAC, 50/60 Hz operation. It dries in less than 25 seconds. The cover is fabricated from one-piece, 16-gauge drawn steel.
Specifications
- Dimensions: 14-7/16 x 10-13/16 x 3-15/16 inches (367 x 275 x 100 mm)
- Electrical service: 115–240 VAC, 50/60 Hz; installation data specifies a 20 A supply, provided by others
- Motor: 0.25 HP, brushless type with dual ball bearings
- Airflow: 185 CFM (314.5 m³/h)
- Air output temperature: 149°F (65°C) at 77°F (25°C) ambient room temperature
- Drying time: less than 25 seconds
Installation and operation
The dryer activates when hands are placed under the sensor. A blue LED in the sensor array guides hand placement, and the unit automatically shuts off after its timeout when the user removes hands from the sensor zone. Surface-mount it using the four supplied 1/4-inch screws, washers, and bushings through the back-plate rubber grommets into suitable prepared mountings; suitable alternative hardware is by others. For masonry walls, use expansion bolts or anchors for 1/4-inch screws. Electrical service is provided and connected by others before the cover is installed; the cover is secured to the back plate with two supplied hex socket security screws.
Install multiple dryers at least 24 inches (610 mm) apart on center. The manufacturer’s reach-dependent guidance sets the bottom of the sensor lens at no more than 48 inches above finished floor for clear forward or side reach, 46 inches for side reach over an obstruction with a reach depth greater than 10 and less than 25 inches, or 44 inches for forward reach over an obstruction with a reach depth greater than 20 and less than 25 inches. For general utility, the manufacturer gives a sensor-lens height range of 44 to 50 inches above finished floor. The manufacturer lists a ten-year warranty from the invoice date.
