ASI 7335-S Toothbrush and Tumbler Holder, Surface Mounted
The ASI 7335-S is a surface-mounted toothbrush and tumbler holder for installations needing a satin-finish Type 304 stainless steel accessory. It holds up to six toothbrushes; check the tumbler opening dimensions below against the tumbler before ordering.
Product specifications
- Finish and material: satin-finish Type 304 stainless steel.
- Capacity: up to six toothbrushes.
- Tumbler fit: a standard tumbler tapering to less than 2-1/4" (57 mm) diameter at the bottom, or a straight tumbler 2-1/8" (54 mm) in diameter with a rim larger than 2-1/2" (64 mm).
- Overall dimensions: 4-1/4" W x 2" H x 4" D (108 x 51 x 102 mm).
- Mounting: surface mounted with mounting plates.
Mounting and placement
Mount the unit using #10 self-threading screws (by others) through the holes in the mounting plates; suitable prepared mountings or other mounting hardware (by others) must suit the wall. Hang the post and flange assemblies on the plates and tighten the setscrews. For general utility, the manufacturer specifies the centerline of the mounting plates at 68" (1727 mm) above the finished floor.
The manufacturer also gives conditional installation-height guidance for accessibility: top of shelf at no more than 48" (1219 mm) above finished floor for clear forward or side reach; 46" (1168 mm) for side reach over an obstruction with reach depth greater than 10" (254 mm) and less than 25" (635 mm); or 44" (1118 mm) for forward reach over an obstruction with reach depth greater than 20" (508 mm) and less than 25" (635 mm). Confirm the applicable requirements and installation conditions for the project.
